-
Home
Your doorway to the internet
Easy ways to expand and enhance your network
Keeping your home wired for quality connections
Everything else you need for a connected lifestyle
-
Smart Home
Keeping an eye on what matters
Smarten up your home devices
Light for every occasion
-
Business
The smarter cloud solution for business networking
High-Speed wired networking from L3 managed to unmanaged
Professional business Wi-Fi with centralized management
Ideal for long range wireless broadband networking
Secure VPN and Load Balance gateways to the business
-
Service Provider
Capable of high-speed network and integrated broadband applications
Maintains internet access wherever you go.
The leading technology for delivering gigabit Internet services
Transforms electrical wiring to carry the network signal.
Easily expand your Wi-Fi coverage.
Boosts your business network with premium performance.
Takes your enterprise Wi-Fi to new levels.
How to set up Deco to work in Access Point mode?
Access Point mode aims to extend the existing wired network and expand the wireless coverage for a home network. At this time, the Deco system will not create its own subnet but purely forward data between the root router and the clients.
Note:
1. Always keep the Deco’s firmware up-to-date to use AP mode. If you’re not sure, please open Deco app, tap “More”, then select “Update Deco” for a check.
2. Please make sure you have installed the latest Deco app to use AP mode.
3. In AP mode, the Deco system will not act as a DHCP server to assign IP addresses to the clients. Please make sure you have enabled the DHCP server function on the root router.
4. In AP mode, since all the clients are managed by the root router, some advanced features will not be available in the Deco app, including Antivirus, Parental Controls, Port Forwarding, Address Reservation, TP-Link DDNS, etc.
5. Ethernet Backhaul is also working in AP mode.
Typical Setup
Step 1. Launch the Deco app, tap “More” on the bottom right corner, and then tap “Advanced”.
Step 2. Tap “Operating Mode”, then choose “Access Point” mode. The app will indicate to reboot the router, tap “OK”.
Step 3. Wait for about 2 minutes until the LED light recovers to solid green, then the Deco system will work in AP mode.
In AP mode, you’re able to change some basic settings in the Deco app including Wireless Settings, LED Control, etc. And you can refer to the link to know the differences between the Access Point and Router mode.
In addition, you can also tap “Advanced”, then tap “Operating Mode” to switch back to “Router” mode.
Get to know more details of each function and configuration please go to Download Center to download the manual of your product.
Your feedback helps improve this site.
SubscriptionTP-Link takes your privacy seriously. For further details on TP-Link's privacy practices, see TP-Link's Privacy Policy.