Search
Search

How to Leave a Powerline network by Pair Button?

User Application Requirement
Updated 12-19-2016 00:54:08 AM 30809
This Article Applies to: 

As the figure shown below, Powerline adapter A, B and C have formed a HomeplugAV Network. The user wants to remove one device (Powerline adapter C) from this network.

 

Step 1   Press and hold the Pair button on Powerline adapter C for at least 10 seconds. Powerline adapter C will restart.( The PWR LED of Powerline adapter C will momentarily extinguish and flash during restarting then illuminate steadily.)

Note:For homeplugAV2 like TL-PA8010P, TL-PA8030P,TL-PA7020P KIT please press and hold the pair button for 8 seconds to leave a Powerline network.

Step 2 Wait for the restart process to complete. After this, Adapter C is removed from this network.

SubscriptionTP-Link takes your privacy seriously. For further details on TP-Link's privacy practices, see TP-Link's Privacy Policy.

Follow Us

About Us
Press
Where to Buy
Learning Center
Sweden / English
Copyright © 2021 TP-Link Corporation Limited. All rights reserved.

From United States?

Check products and services for your region.

Go Other Option