How To Configure the Motion Sensor Feature on the KS220M Smart Switch

Configuration Guide
Updated 11-01-2021 02:48:06 AM 981
This Article Applies to: 

After initially installing your KS220M Smart Dimmer with Motion detection, it may seem like it is not properly working at first.  This is because you may need to enable and configure the motion detection feature before it will properly trigger actions based on detected motion.  This FAQ will guide you through these steps to ensure configuration is successful.

 

Step 1:  Log into your Kasa App and tap on the smart dimmer in your device list

*Note:  Device names listed are customizable and may vary by user

 

Step 2:  Tap on Settings

Step 3:  Tap on Motion Sensor

 

Step 4:  Ensure your Motion Sensor is enabled, then tap on Sensitivity

 

Step 5:  Choose your detection range.  (Far = 25 feet | Mid = 15 Feet | Near = 5 feet)

 

Step 6:  Return to the main device screen and tap on Smart

 

Step 7:  Tap on Create Rule

 

Step 8:  Tap on Add Time

 

Step 9:  Choose the Time then Tap on Trigger

 

Step 10:  Choose your trigger then tap on the back arrow

 

Step 11:  Tap on Brightness, set the desired brightness level, then tap on the Back arrow

Step 12:  Set the trigger for turning the lights off

Step 13:  Set the trigger and tap the back arrow

 

Step 14:  Tap on Save to complete the setup

 

*Note:  You can add up to 4 Time settings so if you want to add more just Tap and repeat steps 7-14.

 

If you need further assistance, please contact support, or visit our community forum here

 

 

Looking for More

Recommend Products

SubscribeTP-Link takes your privacy seriously. For further details on TP-Link's privacy practices, see TP-Link's Privacy Policy.

Be The First To Get Exclusive Deals & News