How to setup my VoIP function on VoIP Modem Router? (new UI)
Preparation: Only after you have Internet access on this router, can you set up your VOIP function successfully.
Here we take Archer VR900v for demonstration.
Login the web interface of the modem. Refer to FAQ.
Go to Advanced>Telephony/VoIP>Telephone Numbers, and click Add.
Choose your Telephony Provider and enter the necessary information as required, and click Save to make the settings effective. Different telephony provider has different parameters. Contact your provider if you don’t know what to put in.
Choose Other as telephony provider if yours is not listed and fill in parameters required. Click Save to make the settings effective.
Phone Number: The number you use to dial and answer.
Registrar Address: Usually a domain name, if not, an IP address.
Authentication ID and Password: Not necessary information, but if you have, fill them in.
For some ISPs in Australia, we have collected info from them. Please refer to the following picture to configure your VoIP function if you have one of the ISPs listed below.
Notice: Where # is a number from 1 to 6 assigned by TPG.
After the set up, please go to Advanced>Telephony>Advanced Settings, set Bound Interface as Any_WAN. See the following picture:
Get to know more details of each function and configuration please go to Download Center to download the manual of your product.
Your feedback helps improve this site.