Securifi Motion Sensor

Smart Home
Updated 07-07-2017 05:59:11 AM 4733
This Article Applies to: 

How to add a Securifi motion sensor to the Deco network?

  • Remove the back cover of the sensor by pushing in the button at the bottom of the sensor, then insert the battery.
  • Launch the Deco app, tap the Add icon at the upper right corner, choose Smart Devices -> Sensors -> Motion Sensor (Securifi) -> NEW DEVICE.
  • Tap NEXT, the app will say Searching…
  • Reattach the rear cover of the sensor and make sure it snaps in place properly.
  • Wait up to 60 seconds until the device is discovered. If not, tap SCAN AGAIN.
  • When the device is discovered, tap NEXT and choose a location for it. Then tap DONE, and the device will list on the app.

 

How to reset a Securifi motion sensor?

Press and hold the Join/Reset button (C) for 10 seconds until the green LED light up briefly.

Note: If the device fails to reset, please refer to the setup guide of the device’s manufacturer for more information.

 

Troubleshooting

Fail to add the sensor / the sensor is offline/unreachable

  • Move the sensor closer to the Deco router;
  • Avoid physical obstructions and radio interference in the surrounding area;
  • Reset the sensor and re-add it to the Deco network.

AbonneerTP-Link hecht veel waarde aan privacy. Voor meer informatie over ons privacybeleid kan je onze Privacy Policy bekijken.

Krijg updates over nieuwe producten, samenwerkingen en ander interessant nieuws

From United States (English)?

Check products and services for your region.