TP-Link Smart Bulb (Wi-Fi)

Smart Home
Updated 11-20-2017 08:47:30 AM 67382
This Article Applies to: 

For LB100/LB110/LB120/LB130

How to add a TP-Link smart bulb to the Deco network?

  • Configure the bulb via Kasa app and connect it to the Wi-Fi network of Deco;
  • Launch Deco app, tap the Add icon at the upper right corner, then choose Smart Devices -> Lights -> Smart Bulb (TP-Link).
  • Tap NEXT, the app will say Searching…
  • Wait up to 30 seconds until the bulb is discovered. If not, please tap TRY AGAIN.
  • When the bulb is discovered, tap NEXT and choose a location for the bulb. Then tap DONE, and the bulb will list on the app.

 

How to reset a TP-Link smart bulb?

  • To reset the bulb without losing the configuration settings:
  1. Turn the light switch controlling the bulb to the OFF position.
  2. Flip the light switch on and off 3 times.
  • To reset the bulb to factory defaults:
  1. Turn the light switch controlling the bulb to the OFF position.
  2. Flip the light switch on and off 5 times.

Note: If the device fails to reset, please refer to the setup guide of the device’s manufacturer for more information.

 

Troubleshooting

Fail to search the bulb / the bulb becomes unreachable/offline

  • Check the light switch of the bulb and make sure it’s always switched to the ON position;
  • Make sure Remote Control is enabled on Kasa app.
  • Move the bulb closer to the Deco router.
  • Avoid physical obstructions and radio interference in the surrounding area.
  • Reset the bulb and reconnect it to the Deco network.

AbonneerTP-Link hecht veel waarde aan privacy. Voor meer informatie over ons privacybeleid kan je onze Privacy Policy bekijken.

Krijg updates over nieuwe producten, samenwerkingen en ander interessant nieuws

From United States (English)?

Check products and services for your region.