Search
Search

How to Disable SIP ALG on TP-Link ADSL modem router

User Application Requirement
Updated 04-02-2014 15:25:04 PM 49770
This Article Applies to: 
Note: This FAQ is not suitable for TD-8840T v4.
 
For the VOIP application, sometimes the ISP will ask you to disable SIP ALG on your modem router. Please refer to the following steps to do the configuration.
Step 1 Press the Windows Logo Key +"R" Key on the Keyboard at the same time or click on Start button->Run to open Run program.
 
Step 2 Type in cmd in the open bar and click OK.
NOTE: In Windows 7,you can also just type cmd in the search bar and
press Enter instead of above two steps .
 
 
Step 3 Type in "telnet 192.168.1.1" (192.168.1.1 is the default IP Address of the modem router, if you have changed it, please type in the matched IP) and press Enter.
 
NOTE:In Win7 or Vista, the telnet command may not be enabled by default, please click on Start button->Control Panel->Programs-> Programs And Features->Turn Windows features on or off,then Check Telnet Client and hit OK to enable telnet command.
 
Step 4 In the telnet page, type in the password for the modem router (default is admin) and press Enter.
 
Step 5 Type in command ip nat service sip sw off.If SIP ALG is disabled successfully, it will show Nat Sip v2 switch off!
 
NOTE：
All of the above settings are temporary. Once you restart or reset the modem, the SIP ALG will be turned back on.

SubscriptionTP-Link takes your privacy seriously. For further details on TP-Link's privacy practices, see TP-Link's Privacy Policy.

Follow Us

About Us
Press
Where to Buy
Learning Center
Canada / English | Français
Copyright © 2021 TP-Link Corporation Limited. All rights reserved.

From United States?

Check products and services for your region.

Go Other Option