-
Home
Create a fast and reliable Wi-Fi
Easy ways to expand and enhance your network
Keeping your home wired for quality connections
Everything else you need for a connected lifestyle
-
Smart Home
Keeping an eye on what matters
Smarten up your home devices
More than on and off
-
Business
The smarter cloud solution for business networking
High-Speed wired networking from L3 managed to unmanaged
Professional business Wi-Fi with centralized management
Ideal for long range wireless broadband networking
Secure VPN and Load Balance gateways to the business
-
Service Provider
Boosts your business network with premium performance.
How do I install TP-Link Archer router to work with a Cable Modem (new logo)?
Note:
If you have a DSL modem and your ISP provides Dynamic IP address for you, please click here;
If you have a DSL modem and your ISP provides static IP address for you, please click here;
If you have a DSL modem and you need to dial up on the computer to get internet from the modem directly, please click here.
Advanced Preparations:
Please refer to the QIG in the packet to connect the hardware.
Note: please make sure you are able to access internet with a direct connection from the main computer to your cable modem. If the direct connection doesn’t work, please contact your Internet Service Provider.
If you are unable to access the internet please do the following:
Here takes Archer C7_V5 as demonstration.
Step 1
Log in to the router’s web-based interface, to get some help, please refer to the article How to log in to the web-based interface of Wi-Fi Routers (new logo)?
Step 2
Configure WAN Connection Type
Select Dynamic IP as the Internet Connection Type on the right of the web page, shown as below. Then click Save button.
Step 3
Wait for a few minutes and check the Internet part on the Status page, if it shows any IP address (similar as below), that means the connection between the Router and the Modem is established. If there is no IP address, please move to step 4.
Step 4
If there is still no IP address, please do the following:
- Restart the router first, wait for about 10 seconds, and connect your end-device like computer, laptop to the router.
- Power off the modem, and unscrew the coaxial cable
- Power on the modem, Check LEDs on the Router, make certain WAN/Internet LED is on.
- Reconnect the coaxial cable to the modem and check if you can access to the internet.
Note: Some cable modem has a back-up battery inside. To completely restart the cable modem, please take the battery out, and then unplug the power supply.
Get to know more details of each function and configuration please go to Download Center to download the manual of your product.
Your feedback helps improve this site.
SubscriptionTP-Link takes your privacy seriously. For further details on TP-Link's privacy practices, see TP-Link's Privacy Policy.