Centralite Plug-In Module

Smart Home
Updated 07-07-2017 05:56:34 AM 41387
This Article Applies to: 

How to add a Centralite plug to the Deco network?

  • Launch the Deco app, tap the Add icon at the upper right corner, choose Smart Devices -> Switchs/Plugs/Outlets -> Plug-in Module (Centralite) -> NEW DEVICE.
  • Plug the device in a wall outlet and power on.
  • Tap NEXT, the app will say Searching…
  • Wait up to 60 seconds until the device is discovered. If not, tap SCAN AGAIN.
  • When the device is discovered, tap NEXT and choose a location for it. Then tap DONE, and the device will list on the app.

 

How to reset a Centralite plug?

  • Unplug any devices from the module and unplug from the wall.
  • Hold the on/off button while plugging it back into the wall.
  • Hold the button until the status LED turns on, which indicates the plug is reset.

Note: If the device fails to reset, please refer to the setup guide of the device’s manufacturer for more information.

 

Troubleshooting

Fail to add the device / the device is offline/unreachable

  • Make sure the plug is factory reset. If not sure, just reset the switch before you add.
  • Move the plug closer to the Deco unit.
  • Avoid physical obstructions and radio interference in the surrounding area.
  • Reset the plug and re-add it to the Deco network.

If the problem persists, please contact our technical support team.

Questa faq è utile?

Your feedback helps improve this site.

Recommend Products

From United States?

Get products, events and services for your region.