- Whole-Home Wi-Fi
- Modems/ Gateways
- Network Expansion
- Smart Home
- Mobile Wi-Fi
- JetStream Switches
- Auranet Businesss Wi-Fi
- Pharos Wireless Broadband
- SafeStream Router
How do I install TP-Link Archer router to work with a Cable Modem (new logo)?Configuration GuideUpdated 04-18-2019 07:33:23 AMThis Article Applies to:Archer AX50 , Archer AX10 , Archer C50 , Archer C5200 , Archer C2(EU)( V3 ) , Archer AX6000 , Archer C59 , Archer C58 , Archer AX1800 , Archer CR700 , Archer C3200 , Archer D20 , Archer D5 , Archer C3150 , Archer C60 , Archer C20 , Archer C8 , Archer C9 , Archer D2 , Archer C6( V2 ) , Archer C20i , Archer C7 , Archer C5400 , Archer C1900 , Archer C25 , Archer C3000 , Archer C1200 , Archer AX1500 , Archer A10 , Archer C2600 , Archer C7i , Archer C5400X , Archer C5 , Archer AX20 , Archer C4 , Archer C2 , Archer AX3000 , Archer D50
If you have a DSL modem and your ISP provides Dynamic IP address for you, please click here;
If you have a DSL modem and your ISP provides static IP address for you, please click here;
If you have a DSL modem and you need to dial up on the computer to get internet from the modem directly, please click here.
Please refer to the QIG in the packet to connect the hardware.
Note: please make sure you are able to access internet with a direct connection from the main computer to your cable modem. If the direct connection doesn’t work, please contact your Internet Service Provider.
If you are unable to access the internet please do the following:
Here takes Archer C7_V5 as demonstration.
Log in to the router’s web-based interface, to get some help, please refer to the article How to log in to the web-based interface of Wi-Fi Routers (new logo)?
Configure WAN Connection Type
Select Dynamic IP as the Internet Connection Type on the right of the web page, shown as below. Then click Save button.
Wait for a few minutes and check the Internet part on the Status page, if it shows any IP address (similar as below), that means the connection between the Router and the Modem is established. If there is no IP address, please move to step 4.
If there is still no IP address, please do the following:
- Restart the router first, wait for about 10 seconds, and connect your end-device like computer, laptop to the router.
- Power off the modem, and unscrew the coaxial cable
- Power on the modem, Check LEDs on the Router, make certain WAN/Internet LED is on.
- Reconnect the coaxial cable to the modem and check if you can access to the internet.
Note: Some cable modem has a back-up battery inside. To completely restart the cable modem, please take the battery out, and then unplug the power supply.
Get to know more details of each function and configuration please go to Download Center to download the manual of your product.Is this faq useful?
Your feedback helps improve this site.Any other feedback?How can we improve it?Thank you
We appreciate your feedback.
Click here to contact TP-Link technical support.