Search
Search

How to setup QoS for VOIP in TD-W8950N,TD-W8960N?

User Application Requirement
Updated 05-25-2015 02:23:08 AM 24008
Ez a leírás a következő eszköz(ök)re alkalmazható:: 

Before you begin, please note:

Suppose the Internet parameters from your ISP are as following and you have connected to the Internet successfully.

Connection type: PPPoE

VPI/VCI: 8/35

User name and password

QoS for VoIP

Here is a typical topology for a small home network, please follow the steps to make the voice data have the highest priority for the whole network.

Configuration for QoS:

Step 1 Open web browser and enter 192.168.1.1 in your address bar, then press "Enter".

Step 2 Enter the username and password of your modem. By default it will be Username: "admin" and Password: "admin" or if you have changed this, please enter the new username and password.

 

 Step 3 Go to Quality of Service, please check Enable QoS

Step 4 Go to Queue Config, then click add button to add a queue. Set following parameters as below:

After save, we will get the rule as below:

Step 5 Go to QoS Classification, then click add button to add a Classification.

Set following parameters:

Note: If QoS is applied in some single computer, please set the Source IP Address with Subnet Mask or Source MAC address in the rule.

After save, we will get the rule as following:

 

Now you can test QoS for VoIP with the settings.

Note: For further information of the options, please refer User Guide coming with the product.

 

Feliratkozás a hírlevélreA TP-Link komolyan veszi az adatok védelmét. További információért látogassa meg a TP-Link Adatvédelmi irányelvek oldalt..

Követés

Rólunk
Sajtó
Hol kapható?
Learning Center
Magyarország / Magyar
Copyright © 2021 TP-Link Corporation Limited. Minden jog fenntartva.
A honlapon szereplő adatok tájékoztató jellegűek. Az oldal szerzője semmilyen felelősséget nem vállal az adatok pontatlanságából eredő károkért.

From United States?

Check products and services for your region.

Go Other Option