How do I install TP-Link Archer router to work with a Cable Modem (new logo)?

Note:

If you have a DSL modem and your ISP provides Dynamic IP address for you, please click here;

If you have a DSL modem and your ISP provides static IP address for you, please click here;

If you have a DSL modem and you need to dial up on the computer to get internet from the modem directly, please click here.

Advanced Preparations：

Please refer to the QIG in the packet to connect the hardware.

Note: please make sure you are able to access internet with a direct connection from the main computer to your cable modem. If the direct connection doesn’t work, please contact your Internet Service Provider.

If you are unable to access the internet please do the following:

Here takes Archer C7_V5 as demonstration.

Step 1

Log in to the router’s web-based interface, to get some help, please refer to the article How to log in to the web-based interface of Wi-Fi Routers (new logo)?

Step 2

Configure WAN Connection Type

Select Dynamic IP as the Internet Connection Type on the right of the web page, shown as below. Then click Save button.

Step 3

Wait for a few minutes and check the Internet part on the Status page, if it shows any IP address (similar as below), that means the connection between the Router and the Modem is established. If there is no IP address, please move to step 4.

Step 4

If there is still no IP address, please do the following:

Restart the router first, wait for about 10 seconds, and connect your end-device like computer, laptop to the router.
Power off the modem, and unscrew the coaxial cable
Power on the modem, Check LEDs on the Router, make certain WAN/Internet LED is on.
Reconnect the coaxial cable to the modem and check if you can access to the internet.

Note: Some cable modem has a back-up battery inside. To completely restart the cable modem, please take the battery out, and then unplug the power supply.

Get to know more details of each function and configuration please go to Download Center to download the manual of your product.

Routerek

Mesh Wi-Fi megoldások

Modemek/Routerek

Hálózatkiterjesztés

SOHO Switches (Kapcsolók)

Mobil Wi-Fi

Adapterek

Egyéb eszközök

Kamerák

Wi-Fi-s konnektor

Wi-Fi-s LED izzók

JetStream Switch

Omada szoftver kontrolleres AP-k

SafeStream Router

Pharos Vezeték nélküli szélessáv

DSL

LTE/3G

PON

Áramköri jeltovábbító

Range Extender

Switch-ek

Üzleti Wi-FI megoldások

How do I install TP-Link Archer router to work with a Cable Modem (new logo)?

How do I install TP-Link Archer router to work with a Cable Modem (new logo)?

Feliratkozás a hírlevélreA TP-Link komolyan veszi az adatok védelmét. További információért látogassa meg a TP-Link Adatvédelmi irányelvek oldalt..

Követés