OSRAM Smart Bulb

Smart Home
Updated 07-07-2017 05:52:32 AM 53101
This Article Applies to: 

How to add an OSRAM smart bulb to the Deco network?

  • Plug in the bulb and power on, the light will blink to indicate it is ready to be paired.
  • Launch the Deco app, tap the Add icon at the upper right corner, choose Smart Devices -> Lights -> Smart LED Light Bulb (OSRAM) -> NEW DEVICE.
  • Tap NEXT, the app will say Searching…
  • Turn the bulb off for one second and then turn it on.
  • Wait up to 60 seconds until the bulb is discovered. If not, tap SCAN AGAIN, while searching, turn off the bulb for one second and then turn it on again.
  • When the bulb is discovered, tap NEXT and choose a location for the bulb. Then tap DONE, and the bulb will list on the app.

 

How to reset a OSRAM smart bulb?

  • Turn ON the bulb for 5 seconds.
  • Turn OFF the bulb for 5 seconds.
  • Repeat the step above four more times for a total of five OFF/ON cycles.
  • After the fifth cycle, turn the light ON and wait for 10 seconds.
  • The bulb will then blink 3 times to indicate it has been reset.
  • Repeat the above steps if the light doesn’t blink.

Note: If the device fails to reset, please refer to the setup guide of the device’s manufacturer for more information.

 

Troubleshooting

Fail to add the bulb / the bulb is offline/unreachable

  • Make sure the bulb is already factory reset before you add.
  • Make sure the bulb has power supply.
  • Move the bulb closer to the Deco unit.
  • Unplug and re-plug the bulb, then try again.
  • Avoid physical obstructions and radio interference in the surrounding area.
  • Reset the bulb and re-add it to the Deco network.

If the problem persists, please contact our technical support team.

Is this faq useful?

Your feedback helps improve this site.

Recommend Products

From United States?

Get products, events and services for your region.