- Whole-Home Wi-Fi
- Modems/ Gateways
- Network Expansion
- Smart Home
- Mobile Wi-Fi
- JetStream Switches
- Auranet Businesss Wi-Fi
- Pharos Wireless Broadband
- SafeStream Router
How to configure TL-WA701ND V2, TL-WA801ND V2, or TL-WA901ND V3 as an Access PointUser Application RequirementUpdated 09-14-2016 00:48:21 AMThis Article Applies to:TL-WA901ND( V3 ) , TL-WA701ND( V2 ) , TL-WA801ND( V2 )
The topology below shows how the access point works:Note：1. To work as an access point, these devices are ‘plug and play’. Please find the default wireless network name and wireless password on the bottom label of the access point. If you want to change the wireless network name or wireless password, please go to 2.2. If this is not the initial setup, please reset the access point to factory default settings firstly referring to here. Then go through all the steps below.Here we take TL-WA701ND V2 and the information below as a reference. If the detailed information for your case is different, please use the corresponding information to configure it.Information of the root router:LAN IP address:192.168.1.254Subnet Mask:255.255.255.0Configuration on the access point:Step 1Please refer to the article that the DHCP is enabled.Step 2Please click Quick Setup on the menu and then go to Next.Step 3Please Select Access Point as the operation mode. Then go to Next.Step 4On the Wireless Settings page, you can change the Wireless Network Name (SSID) to whatever you want. Choose one security type and create a wireless password in the Wireless Password box.Step 5On the Network Setting page, Please make sure the access point’s IP address is in the same IP segment with the Root Router and avoid the IP conflict. In this instance, we can change the IP to “192.168.1.250” and subnet mask to “255.255.255.0”. Then click Next.If your root router is in the different segment like 192.168.0.254, then please change access point’s IP Address to 192.168.0.250.Step 6On the Finish page, please double check all these information and click on Reboot.
After you go through all the above steps, the access point should get working properly with the root router. Please connect this Access Point to the root router with an Ethernet cable.
Get to know more details of each function and configuration please go to Download Center to download the manual of your product.Is this faq useful?
Your feedback helps improve this site.Any other feedback?How can we improve it?Thank you
We appreciate your feedback.
Click here to contact TP-Link technical support.