Click to skip the navigation bar

How to set up Wake-on-LAN on wireless router

User Application Requirement
Updated 08-25-2025 08:55:42 AM Number of views for this article376447
This Article Applies to:

What is Wake-on-LAN?

Wake-on-LAN (WoL) is an Ethernet or Token ring computer networking standard that allows a computer to be turned on or awakened by a network message. The message is usually sent by a program executed on other devices. It is also possible to initiate the message from another network by using subnet directed broadcasts or a WOL gateway service.

Hardware requirements

The mainboard and wired network adapter must support Wake-on-LAN feature.

Software requirements

WakeOnLanGui,LanHelper for Windows or RemoteBoot for IOS.

Here we take RemoteBoot as an example.

RemoteBoot page.

Set up steps:

1. Enter BIOS when start up the computer. Then enable "Resume by PCI Device" and "Resume by PCI-E Device". Usually this option is in power management menu.

Enable "Resume by PCI Device" and "Resume by PCI-E Device".

2. Turn on the computer and go to Control Panel--Network and Internet--Network and Sharing Center--Local area connection--Properties--Configure--Advanced. Then Enable ShutDown Wake-On-Lan, Wake on Magic Packet and Wake on pattem match.

Enable ShutDown Wake-On-Lan.Enable Wake on Magic Packet.Enable Wake on pattem match.

After the settings are done on the computer, we need to do some setting on our Router.

Wake up a PC on WAN side

1.Check MAC address and IP address of the computer need Wake-on-LAN. We call it PC 1 here.

Check MAC address and IP address of the computer.

2.Set IP&MAC binding of PC 1 on our router and enable IP&MAC binding function.

Set IP&MAC binding of PC 1.

Enable ARP Binding.

3. Set Address reservation for PC 1 on our router.

Set Address reservation for PC 1.

4. Open a port for PC 1 by port forwarding function such as virtual server. Here we open port number 3000.

Open a port for PC 1.

5. Now we check the WAN IP address of the Router PC 1 connected. Here the WAN IP is XX.XX.198.136 .

Check the WAN IP address of the Router。

Note:

The WAN IP address is a dynamic IP usually and it may change at any time. In this case, you may try to set up the DDNS (Dynamic Domain Name Server) on the router following theHow to set up TP-LINK DDNS on TP-Link Wireless Router (New Logo). On the RemoteBoot app, the IP will be a domain name you registered with DDNS instead of the WAN IP.

6. Run RemoteBoot app on iPhone from the WAN side. Then fill in the information like below and click BOOT. You can see PC 1 will start up after you click it.

Run RemoteBoot app on iPhone.

Is this faq useful?

Your feedback helps improve this site.

Recommend Products