Search
Search

How to set up QoS for RTSP in TD-8816/8817,TD-W8961ND/W8951ND/W8151N/W8901G/W8901N?

User Application Requirement
Updated 05-25-2015 02:32:02 AM
This Article Applies to: 
TD-8816 , TD-8817 , TD-W8901G

Please make sure Internet is OK first, and then configure QoS as below:

Suppose the topology is as following, please follow the steps to make RTSP data have the highest priority for the whole network.

Configuration for QoS:

Step 1 Open your browser and enter 192.168.1.1 in your address bar, then press "Enter".

Step 2  Enter the username and password of your modem. By default it will be Username: "admin" and Password: "admin" or if you have changed this, please enter the new username and password.

Step 3  Click on "Advanced Setup" on the top menu and click on "QoS",

Set following parameters as below.

Note:If QoS is applied in some single computer, please set the Source IP Address with Subnet Mask or Source MAC address in the rule.

At last click add button to finish adding the rule.

Now you can test RTSP QoS with the settings.

Note: For further information of the options, please refer User Guide coming with the product.

 

SubscriptionTP-Link takes your privacy seriously. For further details on TP-Link's privacy practices, see TP-Link's Privacy Policy.

Follow Us

About Us
Press
Where to Buy
Product Catalogue
Learning Center
Greece / English
Copyright © 2020 TP-Link Corporation Limited. All rights reserved.

From United States (English)?

Check products and services for your region.

Go Other Option