-
RUMAH
SOHO Switches
Keeping your home wired for quality connections
Accessories
Everything else you need for a connected lifestyle
-
Smart Home
Cloud Camera
Keeping an eye on what matters
Smart Plug
Smarten up your home devices
Smart Bulb
Light for every occasion
-
BISNIS
Omada Cloud SDN
The smarter cloud solution for business networking
Switches
High-Speed wired networking from L3 managed to unmanaged
Pharos Wireless Broadband
Ideal for long range wireless broadband networking
SafeStream Router
Secure VPN and Load Balance gateways to the business
-
PENYEDIA LAYANAN
GPON
The leading technology for delivering gigabit Internet services
How to set up rate limit through EAP controller
Suitable for: Omada Controller 2.5.1 or above and EAP products with corresponding firmware.
What is Rate Limit?
Rate Limit is used to set the limit of download rate and upload rate for the clients. With Rate Limit configured, we can protect the network bandwidth from being occupied too much by some of the clients.
Omada Controller supports three types of rate limit: Rate Limit Based on SSID, Rate Limit Based on Clients and Rate Limit Based on Voucher/Local User. When you configure more than one type of rate limit at the same time, only the configuration with minimum rate limit value will take effect.
Note: Only Omada Controller 2.6.0 or above supports Rate Limit Based on Clients.
How Do I Configure Rate Limit?
1. Click on the upper right corner of the management interface. Go to Wireless Settings > Basic Wireless Setting to load the following page.
2. Click to configure the corresponding SSID, and click Rate Limit to load the following page.
3. In the Rate Limit section, enable Rate Limit and specify the download limit and upload limit. Click Apply.
Note: Before configuring Rate Limit Based on Clients, make sure that there are clients connected to the controller.
1. Go to Clients and click to configure the corresponding client. Then click Rate Limit to load the following page.
2. Specify the download limit and upload limit. Click Apply.
Note: Before configuring Rate Limit Based on Voucher/Local User, configure Voucher/Local User Portal first.
For Voucher
1. Click on the upper right corner of the management interface. Go to Wireless Control > Portal to load the following page.
2. Click to configure the corresponding Voucher Portal. Click Voucher Manager to manage the vouchers.
3. On the Management page, go to Voucher and click to create vouchers and specify the download limit and upload limit. Click Apply.
For Local User
1. Click on the upper right corner of the management interface. Go to Wireless Control > Portal to load the following page.
2. Click to configure the corresponding Local User Portal. Click User Management to manage the users.
3. On the Management page, go to User and click to create local users and specify the download limit and upload limit. Click Apply.
Your feedback helps improve this site.