How to use the Recovery Mode to recover the firmware for Omada Hardware Controller

User Application Requirement
Updated 06-27-2022 01:02:44 AM 62579
This Article Applies to: 

In a few cases, your Omada Hardware Controller may become bricked during the firmware upgrade. The most common cause is an unpredictable power failure. This article will guide you to enter the Recovery Mode to recover the firmware.

Step 1. Prepare the firmware.

Download the latest firmware for your Omada Hardware Controller from TP-Link’s official website, unzip to get the .bin file.

For OC200:

For OC300:

Step 2. Configure the computer for recovery

Go to Control Panel -> Network and Internet -> Network and Sharing Center -> Change adapter settings, right-click your Ethernet adapter go to properties -> Internet Protocol Version 4 (for a detailed guide, please refer to How to configure wired TCP/IP Properties of my computer?), and set the IP address/subnet mask as, as shown below.

Step 3. Force Omada Hardware Controller into Recovery Mode.

Unplug the power cable of the Omada Hardware Controller and connect your computer with Omada Hardware Controller directly. It is highly recommended that connect your computer to the ETH2 port of your Omada Hardware Controller.

Press and keep holding the RESET button, then plug in the power cable, after that, the Cloud LED and the LEDs of the connected ports will flash, then wait until the Cloud LED extinguishes, now you can release the RESET button.

Note: If you connect your computer with the ETH2 port of the controller, you can also use ETH1(PoE IN) port for the PoE power supply.

Step 4. Open a Browser to upload the firmware.

Open a browser and input to the address bar, you will enter the following page. Click “Browse” to select the firmware (.bin file), then click “Upgrade Now”. After upgrading, the controller will reboot and work normally.

Note: Firmware recovery will keep all the configurations unless recovering the OC200 with an earlier version of firmware than the current one.

Related Articles:

How to configure wired TCP/IP Properties of my computer?

What to do if you cannot find the page of Omada SDN Controller?

How to back up and restore the configuration and data of your Software Controller (or OC 200)

Looking for More

Чи була ця стаття корисною?

Ваш відгук допомагає вдосконалити цей сайт.

Recommend Products

From United States?

Get products, events and services for your region.