Securifi Motion Sensor

Smart Home
수정일07-07-2017 05:59:11 AM 40911
본 내용은 다음 항목에 적용됩니다: 

How to add a Securifi motion sensor to the Deco network?

  • Remove the back cover of the sensor by pushing in the button at the bottom of the sensor, then insert the battery.
  • Launch the Deco app, tap the Add icon at the upper right corner, choose Smart Devices -> Sensors -> Motion Sensor (Securifi) -> NEW DEVICE.
  • Tap NEXT, the app will say Searching…
  • Reattach the rear cover of the sensor and make sure it snaps in place properly.
  • Wait up to 60 seconds until the device is discovered. If not, tap SCAN AGAIN.
  • When the device is discovered, tap NEXT and choose a location for it. Then tap DONE, and the device will list on the app.

 

How to reset a Securifi motion sensor?

Press and hold the Join/Reset button (C) for 10 seconds until the green LED light up briefly.

Note: If the device fails to reset, please refer to the setup guide of the device’s manufacturer for more information.

 

Troubleshooting

Fail to add the sensor / the sensor is offline/unreachable

  • Move the sensor closer to the Deco router;
  • Avoid physical obstructions and radio interference in the surrounding area;
  • Reset the sensor and re-add it to the Deco network.

해당 FAQ가 유용했나요?

여러분의 의견은 사이트 개선을 위해 소중하게 사용됩니다.

From United States?

해당 지역의 제품, 이벤트 및 서비스를 받아보세요.