Smartenit Motion Sensor

Smart Home
수정일07-07-2017 06:00:58 AM 39994
본 내용은 다음 항목에 적용됩니다: 

How to add a Smartenit motion sensor to the Deco network?

  • Launch the Deco app, tap the Add icon at the upper right corner, choose Smart Devices -> Sensors -> Motion Detector (Smartenit) -> NEW DEVICE.
  • Tap NEXT, the app will say Searching…
  • Press the Auxiliary Button once every 10 seconds to keep the ZBMS3-1 scanning until joined to the network.
  • The Status LED will flash green once when the device finds a viable network to join and then blink 5 times when fully joined.
  • When the device is discovered, tap NEXT and choose a location for it. Then tap DONE, and the device will list on the app.

 

How to reset a Smartenit motion sensor?

Press and hold the Auxiliary button (B) until the Status LED (A) blinks green rapidly, indicating it’s ready to join a network.

Note: If the device fails to reset, please refer to the setup guide of the device’s manufacturer for more information.

 

Troubleshooting

Fail to add the sensor / the sensor is offline/unreachable

  • Move the sensor closer to the Deco router;
  • Avoid physical obstructions and radio interference in the surrounding area;
  • Reset the sensor and re-add it to the Deco network.

해당 FAQ가 유용했나요?

여러분의 의견은 사이트 개선을 위해 소중하게 사용됩니다.

From United States?

해당 지역의 제품, 이벤트 및 서비스를 받아보세요.