TP-Link Smart Bulb (Wi-Fi)

Smart Home
수정일11-20-2017 08:47:30 AM 143607
본 내용은 다음 항목에 적용됩니다: 

For LB100/LB110/LB120/LB130

How to add a TP-Link smart bulb to the Deco network?

  • Configure the bulb via Kasa app and connect it to the Wi-Fi network of Deco;
  • Launch Deco app, tap the Add icon at the upper right corner, then choose Smart Devices -> Lights -> Smart Bulb (TP-Link).
  • Tap NEXT, the app will say Searching…
  • Wait up to 30 seconds until the bulb is discovered. If not, please tap TRY AGAIN.
  • When the bulb is discovered, tap NEXT and choose a location for the bulb. Then tap DONE, and the bulb will list on the app.

 

How to reset a TP-Link smart bulb?

  • To reset the bulb without losing the configuration settings:
  1. Turn the light switch controlling the bulb to the OFF position.
  2. Flip the light switch on and off 3 times.
  • To reset the bulb to factory defaults:
  1. Turn the light switch controlling the bulb to the OFF position.
  2. Flip the light switch on and off 5 times.

Note: If the device fails to reset, please refer to the setup guide of the device’s manufacturer for more information.

 

Troubleshooting

Fail to search the bulb / the bulb becomes unreachable/offline

  • Check the light switch of the bulb and make sure it’s always switched to the ON position;
  • Make sure Remote Control is enabled on Kasa app.
  • Move the bulb closer to the Deco router.
  • Avoid physical obstructions and radio interference in the surrounding area.
  • Reset the bulb and reconnect it to the Deco network.

해당 FAQ가 유용했나요?

여러분의 의견은 사이트 개선을 위해 소중하게 사용됩니다.

From United States?

해당 지역의 제품, 이벤트 및 서비스를 받아보세요.