How to set up Port Forwarding feature on TP-Link SMB Router (new UI)

Configuration Guide
Güncellendi01-19-2024 08:46:33 AM 132132
Bu Makalenin Geçerliliği: 


Due to the existence of NAT feature, traffic from external networks actively accessing the router LAN will be discarded by the NAT. How to allow remote IP to connect to a specific computer or service on the internal LAN? We need to open ports for the server on TP-Link SMB router.

Application Scenario

Take ER7206 V2 as an example. The Web server is behind ER7206 V2 LAN port as WAN1 of ER7206 V2 is Link UP and its IP address is Client could be any IP that is accessible to WAN1. Here we take which is out of WAN1 through the Internet. Our topology is connected as follows.

Configuration Steps

On the main WebUI management page, go to Transmission---->NAT---->Virtual Servers. Click Add. In the popup menu, fill in every option as below screenshot.

Note: The “WAN IP” is an optional parameter. If left empty, the rule will apply to the current WAN IP.

Specify the entry name as WEB_Server, choose the interface as WAN1, and specify the internal/ external port as 2018, enter the IP address of Web server ( as the internal server IP. Select the protocol as ALL, then keep Status of this entry as Enable. Click OK.


On in the topology, when we type in ( is WAN1 of ER7206 v2), we will find it turns out that we could access the Web Server on

Daha Fazlasını Arıyorum

Bu SSS faydalı mı?

Your feedback helps improve this site.

Önerilen Ürünler

From United States?

Bölgeniz için ürünler, etkinlikler ve hizmetler alın.