Search
Search

How to Restore TP-Link Pharos Series Products to Factory Defaults?

Configuration Guide
Updated 02-02-2018 02:17:18 AM 38817
This Article Applies to: 

Note: The reset operation will remove all your settings, and your device will be restored to factory default settings. Do not perform a hard reset unless you have backed up your settings or you can do the configuration again.

There are three methods to reset TP-Link Pharos series products to factory defaults.

Method 1:

With the device powered on, directly press and hold the reset button on the product for about 8 seconds until the Wireless Strength LEDs flash. Then release the button and wait for the device to reset to its factory default settings.

Method 2:

With the device powered on, directly press and hold the remote reset button on the PoE adapter for about 8 seconds until the Wireless Strength LEDs flash. Then release the button and wait for the device to reset to its factory default settings.

Method 3:

Visit the PharOS configuration interface through a web browser. Then go to the SYSTEM page. In the Configuration section, click Reset and wait for the device to reset to its factory default settings.

Note:

  1. The reset process may take several minutes, please wait without any operation.
  2. After the reset, you can use the default access information that can be found on the product label to log in the device.

Sledujte nás

O nás
Tiskové zprávy
Kde zakoupit
Learning Center
Česká republika / Čeština
Copyright © 2021 TP-Link Corporation Limited. Všechna práva vyhrazena.

From United States?

Check products and services for your region.

Go Other Option