-
Otthon
Gyors és megbízható Wi-Fi hálózat létrehozásához
Könnyedén növelje meg, és tegye jobbá hálózatát
Ha több vezetékes kapcsolatra van szüksége otthonában
Amire még szüksége lehet a kapcsolattartáshoz
-
Intelligens otthon
Tartsa szemmel ami fontos
Tegye otthoni eszközeit okosabbá
Fény, minden alkalomra
-
Irodai/üzleti
High-Speed wired networking from L3 managed to unmanaged
Omada szoftver kontrolleres AP-k
Professional business Wi-Fi with centralized management
Secure VPN and Load Balance gateways to the business
VIGI video surveillance is dedicated to your security
Pharos Vezeték nélküli szélessáv
Ideal for long range wireless broadband networking
-
Szolgáltatóknak
Capable of high-speed network and integrated broadband applications
Gondoskodik az internet hozzáférésről, bárhol is legyen.
The leading technology for delivering gigabit Internet services
Átalakítja az áramkört belső/külső hálózat részévé.
Easily expand your Wi-Fi coverage.
Növelje hálózatát kiváló teljesítménnyel.
A vállalkozás vezeték nélküli hálózatát új szintre emeli.
How to configure free authentication policy on EAP Controller
Suitable for: Omada Controller 2.6.0 or above and EAP products with corresponding firmware.
What is Free Authentication Policy?
Free Authentication Policy is used to control the access to the network resources for clients. This function allows some specified clients to access the specified network resources without authentication. Omada Controller supports two match modes: IP-Mac based mode and URL mode.
Free Authentication Policy often works with Portal. With Portal enabled, clients that didn’t pass Portal authentication can only access the network resources allowed by Free Authentication Policy.
How Do I Configure Free Authentication Policy?
Follow these steps to configure Free Authentication Policy:
1. Launch Omada Controller and log in to the management interface.
2. Click on the upper right corner of the management interface. Go to Wireless Control > Free Authentication Policy.
3. Click and configure the policy.
IP-Mac based mode
1) Specify the Match Mode as IP-Mac based. Then give a name for this policy.
2) (Optional) Specify the Source IP Range in which the clients can access the specified network resources. Here we take 192.168.0.0/24 as an example.
3) (Optional) Specify the Destination IP Range of the network resources that is available for the specified clients. Here we take 192.168.0.100/32 as an example.
4) (Optional) Specify the MAC address of the client for the Source MAC. Here we leave this option empty.
5) (Optional) Specify the port number that the service uses for the Destination Port. Here we take 80 as an example.
6) Click Enable to enable this policy.
Note:
- A policy applies to the traffic that matches all the conditions.
- If you leave the optional parameters empty, all the clients can access the network resources without limitation.
URL mode
1) Specify the Match Mode as URL. Then give a name for this policy.
2) Specify the URL that the clients can access. Here we take www.tp-link.com as an example.
3) Click Enable to enable this policy.
4. Click Apply.
Note: The valid port numbers of URL are from 1024 to 65535.
Véleménye segíti az oldal fejlesztését
Feliratkozás a hírlevélreA TP-Link komolyan veszi az adatok védelmét. További információért látogassa meg a TP-Link Adatvédelmi irányelvek oldalt..