-
Otthon
Gyors és megbízható Wi-Fi hálózat létrehozásához
Könnyedén növelje meg, és tegye jobbá hálózatát
Ha több vezetékes kapcsolatra van szüksége otthonában
Amire még szüksége lehet a kapcsolattartáshoz
-
Intelligens otthon
Tartsa szemmel ami fontos
Tegye otthoni eszközeit okosabbá
Fény, minden alkalomra
-
Irodai/üzleti
High-Speed wired networking from L3 managed to unmanaged
Omada szoftver kontrolleres AP-k
Professional business Wi-Fi with centralized management
Secure VPN and Load Balance gateways to the business
VIGI video surveillance is dedicated to your security
Pharos Vezeték nélküli szélessáv
Ideal for long range wireless broadband networking
-
Szolgáltatóknak
Capable of high-speed network and integrated broadband applications
Gondoskodik az internet hozzáférésről, bárhol is legyen.
The leading technology for delivering gigabit Internet services
Átalakítja az áramkört belső/külső hálózat részévé.
Easily expand your Wi-Fi coverage.
Növelje hálózatát kiváló teljesítménnyel.
A vállalkozás vezeték nélküli hálózatát új szintre emeli.
How to Change the Default Ports for EAP Controller?
Suitable for: EAP Controller
The default http port of EAP controller’s web UI is 8088 and default https port is 8043. However EAP controller will force users to use https. In other words, even you type in http://controller_IP:8088 in the address bar it will redirect you to https://controller_IP:8043.
Under some circumstances, for instance another application occupies port 8043, you may want to change the http/https port of the controller. This article is aimed to give you instructions about how to change the default ports.
Step 1 Exit EAP Controller if it is running
Step 2 Find jetty.properties
Go to installation directory of the EAP controller, by default it is %programfiles(x86)%\TP-Link\EAP Controller. Then open properties folder and find the file jetty.properties. Use text editor to open it. The default status is shown as below.
Step 3 Modify the ports and save the file
You could see the entry http.connector.port=8088 (http port) and https.connector.port=8043 (https port). Just modify them to your desired ports but do make sure they are available. Here I change them to 8000 and 8001.
Step 4 Verify it
Run EAP controller and you will be able to use http://controller_IP:8000 or https://controller_IP:8001 to login in to the web UI of the EAP controller.
Véleménye segíti az oldal fejlesztését
Feliratkozás a hírlevélreA TP-Link komolyan veszi az adatok védelmét. További információért látogassa meg a TP-Link Adatvédelmi irányelvek oldalt..