How to configure Jumbo Frame on Omada Controller

Configuration Guide
Дата последнего обновления: 10-17-2024 07:28:41 AM 3722
Эта статья подходит для: 

Contents

Objective

Requirements

Introduction

Configuration

Conclusion

Objective

This article describes how to configure the jumbo frame of switches through the Omada Controller.

Requirements

  • Omada Smart/ L2+/L3 switches
  • Omada Controller (Software Controller / Hardware Controller / Cloud-Based Controller, V5.9 and above)

Introduction

In the traditional Ethernet standard, a frame's maximum length is limited to 1518 bytes. However, as network speed increases, this limitation may lead to insufficient utilization of network bandwidth and reduced processing efficiency, especially in a Gigabit Ethernet environment. In order to solve this problem, Jumbo Frame technology came into being.

Configuration

Step 1. Go to Devices > Device List and click the name of a desired switch to enter its Properties window.

Direct to devices page and select the desired device.

Step 2. Set an appropriate Jumbo Frame value in the Config section, as shown below.

Go to config section in the device configuration page.

Note: To fully utilize the advantages of Jumbo Frame, make sure all devices in the network support this feature.

Conclusion

You have successfully configured the Jumbo Frame on the Controller.

Get to know more details of each function and configuration please go to Download Center to download the manual of your product.

Похожие статьи

Был ли этот FAQ полезен?

Ваш отзыв поможет нам улучшить работу сайта.

Рекомендуемая продукция

Community

Сообщество TP-Link

Нужна помощь? Задавайте вопросы, находите ответы и обращайтесь за помощью к специалистам TP-Link и другим пользователям со всего мира.

Посетить сообщество >

From United States?

Get products, events and services for your region.