-
Dla domu
Większy zasięg, stabilniejsza sieć
Wysoka jakość domowych połączeń przewodowych
Szybkie Wi-Fi dla Twoich urządzeń
Wszystko, czego potrzebujesz na co dzień
-
Smart Home
Bezpieczeństwo domu pod kontrolą
Inteligentne wsparcie dla urządzeń domowych
Oświetlenie na każdą okazję
-
Dla biznesu
Jeszcze inteligentniejsze rozwiązanie chmurowe dla sieci biznesowych
Szybka sieć przewodowa - od przełączników zarządzalnych L3 do niezarządzalnych
Profesjonalny sprzęt sieciowy z możliwością centralnego zarządzania
Urządzenia bezprzewodowe Pharos
Szerokopasmowa sieć bezprzewodowa do użytku na dużych powierzchniach
Bezpieczne biznesowe bramy VPN i routery z równoważeniem obciążenia pasma
Urządzenia do monitoringu VIGI
Niezawodna ochrona przez całą dobę
-
Service Provider
How to set up rate limit through EAP controller
Suitable for: Omada Controller 2.5.1 or above and EAP products with corresponding firmware.
What is Rate Limit?
Rate Limit is used to set the limit of download rate and upload rate for the clients. With Rate Limit configured, we can protect the network bandwidth from being occupied too much by some of the clients.
Omada Controller supports three types of rate limit: Rate Limit Based on SSID, Rate Limit Based on Clients and Rate Limit Based on Voucher/Local User. When you configure more than one type of rate limit at the same time, only the configuration with minimum rate limit value will take effect.
Note: Only Omada Controller 2.6.0 or above supports Rate Limit Based on Clients.
How Do I Configure Rate Limit?
1. Click on the upper right corner of the management interface. Go to Wireless Settings > Basic Wireless Setting to load the following page.
2. Click to configure the corresponding SSID, and click Rate Limit to load the following page.
3. In the Rate Limit section, enable Rate Limit and specify the download limit and upload limit. Click Apply.
Note: Before configuring Rate Limit Based on Clients, make sure that there are clients connected to the controller.
1. Go to Clients and click to configure the corresponding client. Then click Rate Limit to load the following page.
2. Specify the download limit and upload limit. Click Apply.
Note: Before configuring Rate Limit Based on Voucher/Local User, configure Voucher/Local User Portal first.
For Voucher
1. Click on the upper right corner of the management interface. Go to Wireless Control > Portal to load the following page.
2. Click to configure the corresponding Voucher Portal. Click Voucher Manager to manage the vouchers.
3. On the Management page, go to Voucher and click to create vouchers and specify the download limit and upload limit. Click Apply.
For Local User
1. Click on the upper right corner of the management interface. Go to Wireless Control > Portal to load the following page.
2. Click to configure the corresponding Local User Portal. Click User Management to manage the users.
3. On the Management page, go to User and click to create local users and specify the download limit and upload limit. Click Apply.
Twoja opinia pozwoli nam udoskonalić tę stronę.
NewsletterTP-Link poważnie traktuje twoją prywatność. Więcej szczegółów znajdziesz na stronie Informacja o przetwarzaniu danych osobowych.