How to access TP-Link JetStream Managed Switch via the Console port

User Application Requirement
Updated 06-29-2022 02:22:30 AM 191538
This Article Applies to: 

You can use the console cable to connect your PC to the console port of the TP-Link JetStream managed Switch and then manage the switch with the CLI.

Follow the steps below to manage the switch via the console port:

Step 1. Connect your computer to the switch.

If your computer has a serial port (COM), connect it to the console port (RJ45) of the switch, with the RJ45 console cable.

https://static.tp-link.com/upload/faq/image_20210803100103c.png

If you only have USB ports on your computer, you can get a USB-to-RS232 cable. You need to install the RS232 driver for the cable, which is provided by your cable vendor.

You can also choose a Micro-USB cable that supports data transfer to connect your computer to the switch. Then for Windows computers, click here to download and install the TP-Link USB Console Driver then continue. For Mac, please follow FAQ 3177.

Note: If you need to enter the BootUtil menu to reset the switch or recover the password, please refer to FAQ 3146. We recommend an RJ45 Console cable or USB-to-RS232 cable, as it might be more difficult to enter the BootUtil menu with a Micro-USB cable. If you still cannot enter the BootUtil after several attempts, you may get a USB-to-RS232 cable.

https://static.tp-link.com/upload/faq/image_20210803100117t.png

Step 2. Install a Terminal Emulator.

For Windows computers, you need to install a terminal emulator, such as Putty, Tera Term. Go to the official website to download the installer and follow the prompts to install the terminal emulator.

Note: If you use the Micro-USB cable, we recommend “Tera Term”, which you can download and install from the official website.

Step 3. Launch and Configure the Terminal Emulator.

Run your terminal emulator with the following serial parameters

  • Baud Rate: 38400bps
  • Data Bits: 8
  • Parity: None
  • Stop Bits: 1
  • Flow Control: None

For Tera Term, choose the serial port, then go to Setup – Serial Port, set the speed to 38400, then click “New setting”.

For Putty, select Serial, change the Speed to 38400, and then click “Open”.

Step 4 Launching the CLI

Enter the username and password, then you can manage the switch. Please refer to the User Guide, and CLI Reference Guide, which can be found on the support page for your switch model.

Related FAQs

Looking for More

Полезен ли беше този ЧЗВ?

Вашите отзиви помагат за подобряване на този сайт.

Препоръчани продукти

Присъединете се към TP-Link общносттаTP-Link се отнася сериозно към вашата поверителност. За повече подробности относно практиките за поверителност на TP-Link вижте Политиката за поверителност на TP-Link..

From United States?

Get products, events and services for your region.