Search
Search

How to Change the Default Ports for EAP Controller?

User Application Requirement
Updated 01-26-2016 03:15:16 AM 26049
This Article Applies to: 

Suitable for: EAP Controller

The default http port of EAP controller’s web UI is 8088 and default https port is 8043. However EAP controller will force users to use https. In other words, even you type in http://controller_IP:8088 in the address bar it will redirect you to https://controller_IP:8043.

Under some circumstances, for instance another application occupies port 8043, you may want to change the http/https port of the controller. This article is aimed to give you instructions about how to change the default ports.

Step 1 Exit EAP Controller if it is running

Step 2 Find jetty.properties

Go to installation directory of the EAP controller, by default it is %programfiles(x86)%\TP-Link\EAP Controller. Then open properties folder and find the file jetty.properties. Use text editor to open it. The default status is shown as below.

Step 3 Modify the ports and save the file

You could see the entry http.connector.port=8088 (http port) and https.connector.port=8043 (https port). Just modify them to your desired ports but do make sure they are available. Here I change them to 8000 and 8001.

Step 4 Verify it

Run EAP controller and you will be able to use http://controller_IP:8000 or https://controller_IP:8001 to login in to the web UI of the EAP controller.

Присъединете се към TP-Link общносттаTP-Link takes your privacy seriously. For further details on TP-Link's privacy practices, see TP-Link's Privacy Policy.

Следвайте ни

За нас
Преса
Къде да купя
Център за обучение
Bulgaria / Български език
Copyright © 2021 TP-Link Corporation Limited. All rights reserved.

From United States?

Check products and services for your region.

Go Other Option