How to remove the panel of HS200?

There are four fit points that set up the connection between faceplate and main body of switch on the back of HS200.

Remove with bare hands

Before HS200 is mounted in the wall, you need to remove the panel to install the main body conveniently. Please hold the main body of switch, and break off in the direction of one fit point so that all points could be detached in order.

 

Remove with tools

For one special case, if you mount the device in the wall completely and find that you have wrong wire connection, you need to remove the panel firstly and reconnect wires.

 We recommend to use flat hard tool to assist. For instance, we could use straight screwdriver to insert a small crack at one corner of faceplate and fit point is supposed to be detached. Follow the steps for four corners of faceplate and the faceplate could be took down.

This Article Applies to:
HS200
User Application Requirement | Updated 03-07-2017 01:50:08 AM