How to limit the port rate of the incoming traffic via ACL function?

When you use the TP-Link switch, sometimes you need to limit the ingress port rate in order to meet your demand, on the web interface normally we have two method to achieve this goal:
1.    Use “Rate Limit” settings in “QoS---Bandwidth Control” feature
2.    Use “ACL” policy settings in “ACL” menu
Sometimes using the method one could not get a satisfied result, in this text we introduce how to limit port rate by ACL feature, which is the method two.
Note: “ACL” feature does not support engress rate limit, if you want to limit the engress port rate, please use method 1.
Below is an example for setting port 4 ingress rate limited in 1280Kbps, you could refer to this example when you need to do any familiar configuration in your daily use, let’s check step by step:
Step 1 Open the webpage of the switch, then go to “ACL Config” in the “ACL” menu:
Step 2 Choose “ACL Create” and create a new ACL rule:
Step 3 Choose one ACL principle (MAC ACL, Standard-IP ACL, Extend-IP ACL are all alright) to configure the ACL rule which is set in Step2, you do not need to do any other configuration rather than choosing the “operation” to “Permit”:
Step 4 Choose “Policy Config” in the “ACL” menu:
Step 5 Create a policy, here we take the name “ratelimit” for example:
Step 6 In the “Action Create” menu, we bind the policy to the ACL rule we set before, then check the “S-Condition”, set limited rate as 1280Kbps:
Step 7 Choose “Policy Binding” in the “ACL” menu:
Step 8 In “Port Binding”, choose port 4 to bind the policy:
After doing all these below, we have successfully limit the ingress rate of port 4 to 1280Kbps.
This Article Suits for:
TL-SG5428 , T1600G-28PS , T2600G-52TS
User Application Requirement | Updated 09-06-2014 15:12:53 PM