GE Link Smart Bulb

How to add a GE Link Smart Bulb to the Deco network?

• Plug in the bulb and power on.
• Launch the Deco app, tap the Add icon at the upper right corner, choose Smart Devices -> Lights -> GE Link Smart LED Light Bulb (GE) -> NEW DEVICE.
• Tap NEXT, the app will say Searching…
• Turn the bulb off once and then on.
• The light bulb will flash slowly as it is connecting.
• When the flashing stops, the bulb should be discovered. If not, tap SCAN AGAIN, while searching, turn off and then turn on the bulb.
• When the bulb is discovered, tap NEXT and choose a location for the bulb. Then tap DONE, and the bulb will list on the app.

How to reset a GE Link Smart Bulb?

• Plug in the bulb and power on. (It’s recommended to plug the bulb where you can turn it on/off via a wall switch.)
• Turn off the bulb at 3 seconds and on at 3 second intervals (3 seconds off + 3 seconds on = 1 on-off cycle).
• Repeat the on-off cycle (approximately 5 times) until the bulb flashes once.
• As soon as the bulb dims and then goes back to full brightness, it has been reset.

Note: If the device fails to reset, please refer to the setup guide of the device’s manufacturer for more information.

Troubleshooting

Fail to add the bulb / the bulb is offline/unreachable

• Make sure the bulb is already factory reset before you add.
• Make sure the bulb has power supply.
• Move the bulb closer to the Deco unit.
• Unplug and re-plug the bulb, then try again.
• Avoid physical obstructions and radio interference in the surrounding area.
• Reset the bulb and re-add it to the Deco network.

If the problem persists, please contact our technical support team.