How do I configure Traffic Control on TD-W8960N

Why need Traffic Control?
As default, the Internet bandwidth is shared by all clients which means that the bandwidth of each client is uncontrollable while they are sharing the Internet. When someone is streaming on Internet or downloading with P2P software, it will affect the performance of other clients. Traffic Control can help avoid the situation.
 
How to configure Traffic Control?
Note: You´d better set a static IP Address for your each network client in order to manage it easily.
 
Step 1 Open the web browser and type the LAN IP address of the router in the address bar (the default is 192.168.1.1), and then press Enter.
 
 
Step 2 Type the username and password in the login page, the default username and password are both admin.
 
 
Step 3 Go to Advanced Setup-> Traffic Control page, Set the total value of egress and ingress. They should less than the line rate. The line rate is usually the rate provided by your ISP. Check the Enable box and click Save/Apply button.
 
 
Step 4 Go to Traffic Control ->Traffic Control Rule page, click Add button to add a new rule.
 
 
Step 5 Fill in the parameters.
 
  • Rule Status--Set it as Enable.
  • IP Range--Type in IP Addresses of your clients in this bar. If you would like to manage all clients in your network, please type IP Address Range of these computers.
  • Port Range--Type in Port numbers in this bar. If you want to manage all the ports, please leave it as blank.
  • Protocol--TCP/UDP/ALL.
  • Precedence--Set the specific priority for this traffic control rule.
  • It can be Highest/High/Medium/Low/Lowest.
  • Egress Rate/Ingress Rate--You may set Min Bandwidth and Max Bandwidth for Egress Rate and Ingress Rate. You should configure them based your network demand.
  • (The Egress Rate/Ingress Rate is the independent bandwidth for each computer in the IP range list.)
Example:
 
 
Note: 
Min Egress/Ingress Rate must not be empty and no less than 10 Kbps.
Max Egress/Ingress Rate should not be greater than the Egress/Ingress Total Rate, if empty or greater than the Egress/Ingress Total Rate, the actual value will be set with Egress/Ingress Total Rate.
 
Step 7 Click on Save/Apply to save the settings.
 
Get to know more details of each function and configuration please go to Download Center to download the manual of your product.
This Article Applies to:
TD-W8960N( V6 )
User Application Requirement | Updated 06-09-2017 06:16:49 AM