Configuring PPPoE Server on TP-LINK Router
Step 1: Access the router’s management webpage, go to Services->PPPoE Server.
Step 2: Enable PPPoE Server, enter”22.214.171.124” for DNS Server in this example.
Step 3: Look for Authentication, here we selected Local.
Step 4: Look for Auth Protocol, there are PAP, CHAP, MS-CHAP, MS-CHAP v2, we picked them all in this example.
Step 5: Click on Save.
NOTE ： If Dial-up Access Only is enabled, only the dial-in users can access the Internet; If PPPoE User Isolation is enabled, the dial-in users will be unable to communicate with each other.
Step 6: Go to IP Address Pool, enter “test” for Pool Name and ”172.31.10.10-172.31.10.20” IP Address Range, and then click on Add.
NOTE: IP Address pool must be different range from LAN IP address range .
Step 7: Go to Account, enter Account Name and Password, here we entered “test” for account name and “123456” for password.
Step 8: Look for IP Address Assigned Mode, select Dynamic, and then select “test” for IP Address Pool.
Step 9: Under Max Session, enter maximum number of sessions for the client; here we entered “5”.
Step 10: Under Expiration Date, we entered “2012-12-31” in this example.
Step 11: Look for Status, select Activate.
Step 12: Click on Add.
NOTE ： If you select Enable Advanced Account Features, you can use MAC Binding manually or automatically.
Configuring PPPoE Client on PC (Windows 7)
Step 1: Click on Start->Control Panel->Network and Internet->Network and Sharing Center.
Step 2: Click on Set up a new connection or network.
Step 3: Select Connect to the Internet
Step 4: Select Broadband (PPPoE)
Step 5: Enter “test” for Username and ”123456”for Password, and then click on Connect.
Step 6: the PPPoE Connection is established, you can access the Internet now.
Step 7: You can view detailed information of account in List of Account.